Asterisk command list
List of the most important commands to be used by Asterisk client.
How to start the client
he classic method to start the client asterisk is as follows:
asterisk -r
If you want more details on the operations that are performed by the software, start increased verbosity, as in this example:
asterisk -vvvgcr
Once the client has been started, you can run a large number of commands, these are the simplest.
Main Commands
Start Debugging
Asterisk*CLI>set verbose 255
Stop Debugging
Asterisk*CLI>set verbose 0
Start debugging on a particular IP
Asterisk*CLI>set debug ip sip.vira.it
Show SIP status
Asterisk*CLI>sip show registry
Show the list and the status of peers
Asterisk*CLI>sip show peers
Show information about selected peer
Asterisk*CLI>sip show peer 6969XXXXX
Show selected peer debugging
Asterisk*CLI>sip debug peer peer_name
Show general settings
Asterisk*CLI>sip show settings
Notes
These commands may have some variations depending on the installed version of asterisk.
Publication details
Category: Trixbox and Asterisk
Published by: loryzz on date: 27.01.2008 20:14:50
Last edit by: loryzz on date: 02.04.2008 16:54:26
Send to
Ratings
Leave a comment
All comments must be approved by site administrator.
Please write comments on topic. Spam will be never approved.
Trixbox and Asterisk: Linked articles
Backup e ripristino di Trixbox 2.8 published by loryzz in Trixbox and Asterisk
Messaggi di Trixbox in italiano published by loryzz in Trixbox and Asterisk
Installazione di Trixbox published by loryzz in Trixbox and Asterisk
Cosa accade durante una chiamata? published by loryzz in Trixbox and Asterisk
Programmi utili published by loryzz in Trixbox and Asterisk
Ritorna all'inizio
Based total comments
0 %
Comments percentage
0 %